Briggs & Stratton 040213 Manual do Operador descarregar pdf (Página 4)

INSTALLATION

PROCEDURES

Unpacking Precautions

The unit is shipped bolted to its mounting pad, ready for

installation.Avoid damage from dropping, bumping, collision,

etc. Store and unpack carton with the proper side up, as

noted on the shipping carton.

Delivery Inspection

After removing the carton, carefully inspect the Home

Generator System for any damage that may have occurred

during shipment.

IMPORTANT: If loss or damage is noted at time of

delivery, have the person(s) making delivery note all damage

on the freight bill and affix his signature under the

consignor's memo of loss or damage. If loss or damage is

noted after delivery, separate the damaged materials and

contact the carrier for claim procedures. Missing or

damaged parts are not warranted.

Shipment Contents

The Home Generator System is supplied with:

• Home Generator System

• Pre-attached mounting pad

• One 24” flexible hook-up hose

• Installation and start-up manual

• Operator’s manual

• Illustrated parts list manual

• Installation checklist

• Two access door keys

• Four lifting hole plugs

• Oil fill spout

• One spare 15A fuse

• 2 Pole connector - 240V from house

• 10 Pole connector - Sensing and control wires

• Air intake engine cover

• Alternator cover

• Diagnostic LED kit (red LED/plate/screws (2))

Required Specialty Tools/Equipment

• Two 48” lengths of 1” OD pipe (NOT conduit)

• Hole punches for 16ga steel

• Torque screwdriver, 5 to 50 inch-pound range

Home Generator System Location

Before installing generator, consult with homeowner and

convey the following guidelines which may affect the

desired location.

Generator Clearances

Place generator in a well ventilated area, which will allow for

removal of deadly exhaust gas. DO NOT install generator

where exhaust gas could accumulate and enter inside or be

drawn into a potentially occupied building. Ensure exhaust gas

is kept away from any windows, doors, ventilation intakes or

other openings that can allow exhaust gas to collect in a

confined area (Figure 1). Prevailing winds and air currents

should be taken into consideration when positioning generator.

• Observe that the 15 Amp fuse has been removed from the

control panel for shipping.

• DO NOT install this fuse until all plumbing and wiring has

been completed and inspected.

Installing the 15A fuse could cause the engine to start.

CAUTION

• Operate generator ONLY outdoors.

• Keep exhaust gas from entering a confined area through

windows, doors, ventilation intakes or other openings.

Running generator gives off carbon monoxide,

an odorless, colorless, poison gas.

Breathing carbon monoxide will cause nausea,

fainting or death.

WARNING

• Keep at least 5 ft. (152 cm) clearance on all sides of generator

including overhead.

Exhaust heat/gases can ignite combustibles or

structures causing a fire.

WARNING

Figure 1 — Home Generator System Clearances

Exhaust port must be

5 ft (152 cm)

minimum distance

from building openings

Exhaust Port

1 2 3 4 5 6 7 8 9 ... 47 48

Comentários a estes Manuais

Sem comentários

Briggs & Stratton 040213 Manual do Operador Página 4

Comentários a estes Manuais

Manuais e produtos relacionados com Geradores de energia Briggs & Stratton 040213