Briggs & Stratton 040213 Manual do Operador descarregar pdf (Página 11)

INSTALLATION

Generator AC Connection System

A single-phase, three-wire AC connection system is used in

the Home Generator System.The stator assembly consists

of a pair of stationary windings with two leads brought out

of each winding.The junction of leads 22 and 33 forms the

neutral lead, as shown schematically and as wiring diagram

in Figure 10.A complete schematic and wiring diagram can

be found in the illustrated parts list manual.

NOTE: Neutral is not bonded to ground at generator.

Grounding the Generator

Ground the Home Generator System per applicable codes,

standards, and regulations.The generator GND lug is

located inside the control panel door under the circuit

breaker cover.

Utility Circuit Connection

"240V Utility" leads must be routed in conduit. Functions

are briefly described as follows:

• "240V Utility" delivers power to the generator’s circuit

board, optional battery and oil warmer, charge the

battery and when utility is lost the generator will start.

Using installer-supplied minimum 300V, 14 AWG stranded

copper wire, connect each control circuit terminal in the

generator to the Automatic Transfer Switch.

Fault Detection System

The generator's control panel has a digital display to show

fault codes. It will display a fault code if certain faults are

detected in the HGS.An extra LED and mounting plate is

supplied so that it can be installed at a convenient indoor

location. It will turn on and off in a series of blinks if certain

faults are detected in the HGS.The owner will use it to

observe the status of the HGS. Consult with the owner for

a convenient location.

To install the remote LED panel:

• Push the LED through the mounting plate from the front

until it snaps in place.

• Using minimum 18 AWG wire, connect the remote LED

to the generator control board using supplied 10 pole

plug. Use wire nuts to attach wire to LED leads.

IMPORTANT: The LED is polarity sensitive.

• Attach mounting plate to installer-supplied electrical box.

Refer to the section “Fault Detection System” in the

Operator’s Manual for operation.

Figure 10 — System AC Connections

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 47 48

Comentários a estes Manuais

Sem comentários

Briggs & Stratton 040213 Manual do Operador Página 11

Comentários a estes Manuais

Manuais e produtos relacionados com Geradores de energia Briggs & Stratton 040213